NEWSTYLE 24V 15A 360W DC Universal Regulated Switching Power Supply Adaptor Transformer for CCTV Radio Computer 3D Printers

Specifications:

 -Input Voltage: 110V/220V AC

 -Output Voltage: 24V DC

 -Output Current: 0~15A

 -Protection: Shortage Protection; OverloadProtection; Over Voltage Protection

 -Weight: 660g

 -Size: 215*114*50mm

 -Shell Material: Aluminum

 -Safety Compliance: FCC / CE

 

Connection:

-L, N: AC power input

-COM: DC power output “-“

-V: DC power output “+”

-+V / ADJ: Adjust the output voltage (10%)

Note:

-1. In-door use only, for this switch powersupply is not waterproof.

-2. 110V/220V is selected by switch. Beforepower on please check input voltage avoiding damage.

Product Features

  • √ IN-DOOR USE ONLY!
  • √ High quality Switch Power Supply Widely used in Industrial automation, LED display, communications, etc.
  • √ You can choose the input voltage (110V/220V) by switch.
  • √ Smart device surge protection for Shortage Protection, Overload Protection, Over Voltage Protection
  • √ 3 Months Warranty Period, Money back guarantee or replacement if there are any problem with our products.

Click Here For More Information

Published by

Best 3D Printer

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

3 thoughts on “NEWSTYLE 24V 15A 360W DC Universal Regulated Switching Power Supply Adaptor Transformer for CCTV Radio Computer 3D Printers”

  1. So far no problems easy, access to terminals with a click down shield … I bought this to run LED lights and a work bench power supply for hobby project builds. So far no problems easy, access to terminals with a click down shield lid and main power located at end of same connector block also power led and output adjuster. There are multiple pre tapped screw mounting holes on the case to allow fixing in permeant position or in case to protect it from water, dust and tampering. Multiple vent slots and top mounted fan. Whilst powered up and running lights over a…

  2. The fan isn’t too loud and keeps it nice and cool inside I got this for my Anet A8 to replace the generic, fan-less and questionably safe power supply. I could only mount with one screw but it is in tight enough so there is no movement. The fan isn’t too loud and keeps it nice and cool inside.This power supply also gives the correct amount of power as is required for the printer, theoretically you can get away with the stock printing just PLA but ABS is a no go, it is still better to upgrade as the components in the original power supply seem…

  3. About what you’d expect from a cheap PSU The fan speed isn’t temperature based as the images indicate. It spins up, apparently at full speed, as soon as any load is applied, far too quickly for it to be using a thermistor. The fan isn’t overly loud, although it would benefit from some temperature related speed scaling. I’ve no way of verifying the current capabilities of the PSU, although it does at least appear to bring my 3D printers hot end and bed up to temperature more quickly than the supplied 20A (apparently 15A real-world…

Leave a Reply