This expansion board is designed for the Raspberry Pi 3B and is used to run NanoDLP’s light-cured 3D printers. The board contains a 9-28V to 5V circuit that provides a maximum of 3A and other interfaces required by NanoDLP.
9V-28V to 5V@3A Buck Converter. DRV8825 Stepper Driver. 12V Fans (cooling the Pi). 2X Endstops. Controled MOS for ext LED driver. I2C Connector for LCD1602. Uart Connector for Touch Screen. Shutter support. 5V OUT Connector for ext Board. 1602 LCD screen board compatible for Arduino UNO, Leonardo, Mega, 101 (Intel Curie), DUE, Micro, Mini, Nano. Application: for NanoDLP software on Raspberry Pi.
Condition: 100% brand new
Module power supply voltage: 5V
Interfaces: one I2C/TWI, 2-wire data communication interface, and 2 gadgeteer interfaces
I2C interface address: 0x20-0x27 (factory default address 0x20)
Backlight: blue, white characters
1 x NanoDLP Shield V1.1 Expansion Board
1 x Heat Sink
1 x 1602 LCD Screen
1 x 4-pin connector cable
- 9V-28V to 5V@3A Buck Converter.
- DRV8825 Stepper Driver.
- Controled MOS for ext LED driver.
- 1602 LCD screen board compatible for Arduino UNO, Leonardo, Mega, 101 (Intel Curie), DUE, Micro, Mini, Nano.
- Application: for NanoDLP software on Raspberry Pi.